Bedding Material in Dirt-Floor Pens Reduces Heat
During the summer months when 'heat load' is high the use of wheat straw as bedding on dry dirt flooring can lower temperatures, a Kansas State Cow-Calf Unit project has found.Introduction
Weather-related stressors are a well-recognized opponent to animal welfare and can
have important ramifications for animal performance. Sound animal husbandry practices
historically have attempted to diminish the effects of deleterious environmental
factors. Providing aid to animals when temperatures are above or below their thermal
neutral zone (TNZ) can improve animal welfare and/or performance.
Because most
breeds of cattle are not well equipped to deal with heat, the temperatures at which heat
stress can begin to affect cattle can be surprisingly low. The onset of mild heat stress can
occur at a temperature humidity index (THI1) value of 75, which can correspond to an
ambient temperature as low as 78°F.
Aside from food, water, and shelter, arguably the most widely used intervention to
counteract the elements is the provision of bedding material during times of cold
weather or during events for which the stress of cold may prove too difficult for animals
to compensate (i.e., calving, illness, etc.). By providing a layer of insulation as bedding
for animals, heat exchange via conduction from their body to the earth is decreased,
allowing them to maintain body temperature at a much lower cost to their metabolism.
This basic principle of insulation also may be applied in times of heat stress.
In an attempt to decrease the effects of heat stress in feedlot cattle, some producers
apply wheat straw or grass hay as bedding material, hypothesizing that bedding acts as
an insulator from the pen floor, which otherwise serves as a reservoir and conductor of
heat. Bedding materials normally are lighter in color than the pen surface, and therefore
have less solar heat gain.
As far as Kansas researchers are aware, no studies have been conducted
to examine the effects of these bedding materials on the temperature of the pen surface.
Additionally, determining the effects of varying thicknesses of manure on pen surface
temperatures may provide useful information for management decisions regarding pen
cleaning and maintenance.
Experimental Procedures
Plots (each approximately 21.5 ft2) within a dirt-surfaced feeding pen near Manhattan,
KS, were assigned randomly to 1 of 4 treatments, with 4 separate plots per treatment.
Treatments consisted of a bare pen surface, wheat straw applied at a depth of 6 inches,
and manure applied to the bare pen surface to depths of 6 and 12 inches. Surface
temperatures of treatment plots were measured by a handheld infrared thermometer
(Fluke, Inc., Everett, WA) with an accuracy of ±1.5% and a pre-set emissivity of 0.95.
Measurements were collected every 30 minutes for 5 hours from 11:00 a.m. through
4:00 p.m. on June 30, 2011. Temperature measurement was conducted at a similar
height and angle at each measurement time point.
Environmental weather data were measured using a multi-sensor onsite weather station (Campbell Scientific, Logan, UT)
operated by the Kansas State University Turfgrass team. Data were analyzed using the
MIXED procedure of SAS (SAS Institute, Cary, NC) with repeated measures over
time. Significance was declared at P < 0.05 and tendencies at P < 0.10.
Environmental Conditions During the Experimental Period | ||||
---|---|---|---|---|
Item | Dry bulb temperature, °F | Relative humidity, % | Wind speed, MPH | Solar radiation, Langley |
Mean value | 97.9 | 31 | 3.6 | 780 |
Results and Discussion
During the period of time when surface temperature measurements were collected, the
dry bulb air temperature averaged 97°F (Table 1) with a corresponding relative humidity
value of 31%. Although the relative humidity was not considered extreme, the air
temperature was high enough to result in a THI that would be considered a time of
severe risk for heat stress in cattle.
Application of wheat straw at a depth of 6 inches significantly decreased the surface
temperature of the test plot versus all treatments (P < 0.05, Table 2). Face temperature
was 25°F greater for the bare pen surface and with 6 inches of manures compared with
wheat straw bedding (P < 0.001); however, surface temperature of the wheat straw
plots was only 6°F cooler than the plots with 12 inches of manure (P = 0.03).
The
decreased surface temperature associated with wheat straw likely occurred as a result
of a decreased absorbance of radiated solar energy due to the light color of the wheat
straw. Pen surfaces absorb and accumulate heat from solar radiation, and the insulative
properties of wheat straw likely played a role in diminishing solar heat gain. Materials
with properties similar to those of wheat straw (corn stalks, poor-quality grass hay, etc.)
could have comparable effects on surface temperatures of cattle feeding pens.
It is plausible that 12 inches of manure provided more insulation from the pen floor
than 6 inches of the same material, which resulted in a decreased face temperature
(P < 0.001), but further investigation is needed, and allowing excessive accumulation of
manure is not advised.
Surface Temperature of Different Materials in a Cattle Feeding Pen | ||||||
---|---|---|---|---|---|---|
Pen surface treatment | ||||||
Item | Bare surface | 6 in. wheat straw | 6 in. manure | 12 in. manure | P-value | SEM |
Surface temperature, °F | 136.6a | 111.6b | 136.7a | 117.8c | <0.0001 | 2.04 |
abc Means with different superscripts differ significantly (P < 0.05). |
Implications
These observations indicate that the use of wheat straw as a bedding material in dry dirtfloor cattle feeding pens can decrease the surface temperature of the bedded area, which may offer cattle a cooler place to rest in times of high heat load.
Acknowledgements
The authors thank the Kansas State University Commercial Cow-Calf Unit for use of facilities, the Kansas State University Turfgrass team for weather readings, and the Livestock and Meat Industry Council for funding of materials. Much gratitude is extended to Tanner Miller, Erica Biel, Taylor Swanson, and Mark Meier for assistance with the project.
Further ReadingYou can view the full report by clicking here. |
January 2013